JTX Family

The JTX family of devices represents the evolution of gateway technology. Targeted specification at many new and emerging technologies including ATCA and Micro ATCA. The devices themselves are a super set of the JTS family. Uniquely the JTX gateways are based on a true dynamic cross point architecture. They are Ideally suited for high-end applications with LSP counts up to 15 in a single device. This feature rich family will allow our client base to design in the next generation architectures with confidence.

Features include:

• True cross point architecture (Where and LSP can become the primary bus)
• Up to 50 Mhz system performances
• Support for 5, 7, 9, 12 and 15 local scan chains addressable via the IEEE 1149.1 interface.
• Support for Pass-through
• Device Multi-Drop Addressable via the IEEE 1149.1 protocol
• Independent Chain concatenation Mode (ICCM)
• Generic I/O: Supports test pattern compliance
• Clock monitoring pins (software selectable)
• Support for Pass-through
• Device Multi-Drop Addressable via the IEEE 1149.1 protocol
• Support for Status instruction enabling non-intrusive monitoring of the system card.
• Programmable TRST and SELFTEST pulse width (user programmable)
• Local Scan port enable signal provides the ability to use non IEEE 1149.1 compliant devices that require JTAG enable signal.
• Provides the ability to initiate Self Test on a remote PCB via a standard IEEE 1149.1 command.
• Multi Voltage User selectable I/O (supports 3.3, 2.5 and 1.8V)